Lattepanda CR200 broken ON/OFF push button

If you're having trouble with your LattePanda Alpha & Delta, here's the place to get help.
Forum rules
If you have not found a solution, post a new issue. To speed up the process please let us know:
- Have you tried the solutions listed above?
- What board are you using? Standard (2GB RAM/32GB eMMC) or Enhanced (4GB RAM/64GB eMMC)?
- Have you tried any other solutions?
- How long have you had your board for?
- When did you first boot your board?
- Did it work ok before the issue occurred or has the issue always been there?
- Use images and videos to help us understand the issue where possible

If you are seeking RMA:
- Please open a new topic rather than hijacking someone else's thread
- Mark RMA posts with [DEFECTIVE] + <helpful description of issue>. We can then approve/disapprove each request
- Completed RMA cases will be marked with [CLOSED]
You can find the RMA guide [here]

Resolved Issues
- If you manage to fix an issue, please share your solution for the good of the community. It could help someone else in future.
- If an issue is resolved the thread should be marked as [RESOLVED]. We can then sticky the thread to help people in future.
Post Reply
User avatar
pizvi
Posts: 2
Joined: Sun Sep 15, 2019 10:42 am

Mon Oct 07, 2019 1:17 pm

good day to everyone..

i desoldered original on/off push button from my CR200 bacause i need external button for powering on this board and solder wires on PCB pads (1,8V pad) to extend button on box.. unfortunately moving cables inside box caused ripping off one solder pad from PCB so there is now no chance i can power on my lattepanda..

is there any different solution to power on my board?

@lattepanda you guys have circuit schemes - is somewhere on the board another 1,8V on/off switch pad?

i can try to set autoboot in bios, but now i cant even power on my board :(

Image

thank in advance

User avatar
LattePanda
Site Admin
Posts: 2467
Joined: Wed Jan 20, 2016 9:09 am

Wed Oct 09, 2019 10:12 am

Hi,

Here is a pic for your reference.
1.png
1.png (2.48 MiB) Viewed 782 times
if the solder pad is ripped off, please try to remove the surface coating to expose the the conductive region. There are many maintenance videos on YouTube.

Please do be careful of short circuit when welding.
Enjoy Tinkering with LattePanda ! :lol:

Post Reply