Page 1 of 1

Fitting the LattePanda into 3.5" drive bay?

Posted: Fri Jun 14, 2019 8:41 am
by Dreamwalker
According to the site the LattePanda Alpha/Delta has the following dimensions

115mm x 78mm x 14 mm and the 3.5" form factor is 147mm x 101mm x 19mm - 26.1mm

So it should fit into that space I was wondering if anyone has attempted this? Is there already a way to mount this in a 3.5" slot available? (not seen anything)

I am thinking of making a 6 node docker cluster (docker swarm or kubernetes) into an old NAS style PC case ( ... x-nas-case).

Re: Fitting the LattePanda into 3.5" drive bay?

Posted: Wed Jun 19, 2019 8:56 am
by Dreamwalker
Guess no one has tried this.

I'm thinking I need to keep the tray to a minimum so might try fitting into one of these. ... ay&sr=8-15

I need the spacing for the latte panda alpha screw points though to ensure the SSD ones don't conflict. And I am thinking need to use a couple of washers and bolt through the frame I want to keep the fan open as much as possible so the chassis fan can push cool air through to it.