LattePanda Forum

They posted the mipi interface in the forums. It would be better if they put on their website.

viewtopic.php?f=6&t=37&p=2038&hilit=Mipi#p2038

Thanks for the tips. Do you have any suggestions on how to increase voltage if you Are using a lipo battery?

I'm not familiar (yet) with UWP so for me some small tutorials would be nice. Some basic tutorials (with examples for download) on how to use the GPIO pins connected to the Atom. Also I need support on using the Arduino I/O from windows. I prefer everything in C(++) and not C# And how to use these 3...

Mario,

for me it just works fine. I didn't get a message it was connected, but it shows up in the windows explorer screen.

I have attached a screenshot.

Hi, I'm also trying to find the same Answers. Are the two UART channels to be used as COM1? I had a look in the device tree in windows. There I see 7 I2C controllers. Are the addresses starting from 30? Or should I use something else? I would appreciate some sample code in C(++) From the Intel atom ...

Nice!

How did you connect the lp to a battery?

ok below is some sample code /* this sketch reads on/of status of the atom processor if the atom is on a LED will be switched on if the atom is of the LED will go off using the 1.8V input from the Atom as input on analogue A0 pin16 outputting a high signal on digital output D4 pin10*/ int AtomStatus...

I had a similar thing turned out that i had the change a setting in the monitor. It was something like overscan, but I'm sure every brand has its own name and setting for this

Did you buy one with Windows 10 pre installed. As I understand now some boards get shipped without Windows 10.

I believe 32GB/2GB is sold with and 64GB/4GB without.

I was wondering almost the same thing, but in reverse. How to shut off the lan port after switching off the LP, because it keeps on blinking and if wake on loan is not on it is a bit useless.