LattePanda(Old) Doesn't boot - just red & blue light turned on

If you're having trouble with your LattePanda, here's the place to get help.
Forum rules
    Post technical issues here.

    - Discussion tone should be kept polite and focused on facts
    - Vulgar language or flaming constitutes an instant ban
    - Please note we cannot support PM requests for help
    - Members are asked to post in English only so that posts can be well received and properly monitored
    - You can find the RMA guide [here]
    - Please check if your question has already been answered before opening a new thread. If it has not, please verify the following:


    - Have you tried a hard reset?
    - Are you using a 5V@2A+ power supply and a high quality USB cable?
    - Have you tried powering the board through the CN2 headers?
    - Have you tried a cooling solution such as a fan or heatsink?
    - Have you tried reinstalling drivers?
    - Have you tried reloading the operating system?
    - Have you tried flashing the BIOS?
    - Are you able to flash the BIOS at the hardware level?

    If you have not found a solution, post a new issue. To speed up the process please let us know:
    - Have you tried the solutions listed above?
    - What board are you using? Standard (2GB RAM/32GB eMMC) or Enhanced (4GB RAM/64GB eMMC)?
    - Have you tried any other solutions?
    - How long have you had your board for?
    - When did you first boot your board?
    - Did it work ok before the issue occurred or has the issue always been there?
    - Use images and videos to help us understand the issue where possible

    If you are seeking RMA:
    - Please open a new topic rather than hijacking someone else's thread
    - Mark RMA posts with [DEFECTIVE] + <helpful description of issue>. We can then approve/disapprove each request
    - Completed RMA cases will be marked with [CLOSED]
    You can find the RMA guide [here]

    Resolved Issues
    - If you manage to fix an issue, please share your solution for the good of the community. It could help someone else in future.
    - If an issue is resolved the thread should be marked as [RESOLVED]. We can then sticky the thread to help people in future.

    What does troubleshooting support?
    - Hardware queries
    - Hardware issues that weren’t caused by you, e.g DOA board
    - Windows 10 specific issues
    Post Reply
    User avatar
    KLBSice
    Posts: 1
    Joined: Sun Dec 16, 2018 2:44 am

    Sun Dec 16, 2018 2:57 am

    Suddenly my LP didn't boot.
    The red and blue lights still turned on,
    but monitor showed me a black screen.

    I tried hard reset.
    I tried using another cable and another power supply.
    I tried powering through CN2 connector,
    Even though I tried powering through Arduino connector.
    I wasn't able to reinstall drivers & os reinstall & flash new bios
    Because display didn't turn on.

    This is enhanced lattepanda, contains 4GB of ram, 64GB of eMMC.

    Mouse was turned on. Just like lp booted fine.

    I checked it is not issue of HDMI cable or monitor.

    It just showing red light and blue light.
    Sometimes red light just blinking.

    Please somebody help me...

    User avatar
    fruvous
    Posts: 6
    Joined: Fri Sep 02, 2016 9:01 pm

    Mon Feb 18, 2019 11:55 pm

    I'm having the same issue here with my LP original.

    Post Reply