Lattepanda CR200 broken ON/OFF push button

userHead pizvi 2019-10-07 21:17:11 7467 Views2 Replies
good day to everyone..

i desoldered original on/off push button from my CR200 bacause i need external button for powering on this board and solder wires on PCB pads (1,8V pad) to extend button on box.. unfortunately moving cables inside box caused ripping off one solder pad from PCB so there is now no chance i can power on my lattepanda..

is there any different solution to power on my board?

@lattepanda you guys have circuit schemes - is somewhere on the board another 1,8V on/off switch pad?

i can try to set autoboot in bios, but now i cant even power on my board

Image

thank in advance