LP Delta issue after flashing to auto power on

If you're having trouble with your LattePanda Alpha & Delta, here's the place to get help.
Forum rules
If you have not found a solution, post a new issue. To speed up the process please let us know:
- Have you tried the solutions listed above?
- What board are you using? Standard (2GB RAM/32GB eMMC) or Enhanced (4GB RAM/64GB eMMC)?
- Have you tried any other solutions?
- How long have you had your board for?
- When did you first boot your board?
- Did it work ok before the issue occurred or has the issue always been there?
- Use images and videos to help us understand the issue where possible

If you are seeking RMA:
- Please open a new topic rather than hijacking someone else's thread
- Mark RMA posts with [DEFECTIVE] + <helpful description of issue>. We can then approve/disapprove each request
- Completed RMA cases will be marked with [CLOSED]
You can find the RMA guide [here]

Resolved Issues
- If you manage to fix an issue, please share your solution for the good of the community. It could help someone else in future.
- If an issue is resolved the thread should be marked as [RESOLVED]. We can then sticky the thread to help people in future.
Post Reply
User avatar
gwynethh15
Posts: 15
Joined: Tue Mar 13, 2018 1:47 pm
Location: Maine USA

Mon Feb 03, 2020 2:14 pm

Has anyone flashed the Delta to auto power on? Has anyone had slow boot issues after doing that? How did you fix that?
We flashed the Delta to get auto power on and after the flash had very slow (over a minute) boot up into windows 10 from both the eMMC and a m2 SSD. Both worked perfectly prior to to the auto boot flashing. Removal and return to normal power on resulted in failure to boot to windows even after Win 10 re-installation. Attempting to reflash to the "OEM" Delta bios resulted in mismatch messages.

Now looking to flash a new BIOS chip (off board) and replace the Deltas BIOS chip be un-soldering/re-soldering.

We used the firmware in the Github repository.

User avatar
gwynethh15
Posts: 15
Joined: Tue Mar 13, 2018 1:47 pm
Location: Maine USA

Mon Feb 10, 2020 1:23 pm

So no one else try to "auto power on" their Delta? No one from LattePanda has replied to our issue nor have they corrected their post providing a "return to original bios" at https://www.lattepanda.com/topic-f23t20946.html.

After the above issues we purchased a new Delta but still need to set it up for auto power on. We are reluctant to flash the BIOS of the new board until LP can fix that post and they or someone else can confirm "auto power on" works OK without the unacceptable slow boot to Windows.

PS We understand this is/was a major holiday in China and the corona virus issues may have delayed their response. Hope to hear from someone soon..

User avatar
gwynethh15
Posts: 15
Joined: Tue Mar 13, 2018 1:47 pm
Location: Maine USA

Thu Feb 20, 2020 2:09 pm

Bump for help please

Post Reply