[Tutorial] of Titan Case Assembly

userHead Queenie.Le 2019-01-11 10:46:31 29869 Views11 Replies

Here I will share my Titan case assembly process with you guys.

What you received: LattePanda Alpha/Delta Board and Titan Case. 

修正2.jpg 

 

1.First, remove the two wings of the upper half of Titan case.
(Tip: It would be easier to disassemble them by pulling away from the middle of the wings) 修正1.jpg 

 

2.Then put your LattePanda Alpha/Delta into Titan case.
(Tip 1: It could be easier if you put the side with audio jack into the case first.
Tip 2: In this step, you can install the antenna, SSD, eDP and Touch connectors before closing the lower half of Titan case, and the rest parts,such as SD card, Ethernet cable and USB ports, should be connected after installation.) 

修正4.jpg 

 

3.After the upper and lower half of Titan case are installed, screw the four corners. 修正5_副本.jpg 

 

4. Then buckle the wings and complete the installation: 

修正6.jpg 

 

 5. After installation, the ports of each side are as follows:

 细节图1.jpg 

细节图3.jpg 

 细节图2.jpg 

 细节图4.jpg