Not powering on

If you're having trouble with your LattePanda, here's the place to get help.
Forum rules
    Post technical issues here.

    - Discussion tone should be kept polite and focused on facts
    - Vulgar language or flaming constitutes an instant ban
    - Please note we cannot support PM requests for help
    - Members are asked to post in English only so that posts can be well received and properly monitored
    - You can find the RMA guide [here]
    - Please check if your question has already been answered before opening a new thread. If it has not, please verify the following:

    - Have you tried a hard reset?
    - Are you using a 5V@2A+ power supply and a high quality USB cable?
    - Have you tried powering the board through the CN2 headers?
    - Have you tried a cooling solution such as a fan or heatsink?
    - Have you tried reinstalling drivers?
    - Have you tried reloading the operating system?
    - Have you tried flashing the BIOS?
    - Are you able to flash the BIOS at the hardware level?

    If you have not found a solution, post a new issue. To speed up the process please let us know:
    - Have you tried the solutions listed above?
    - What board are you using? Standard (2GB RAM/32GB eMMC) or Enhanced (4GB RAM/64GB eMMC)?
    - Have you tried any other solutions?
    - How long have you had your board for?
    - When did you first boot your board?
    - Did it work ok before the issue occurred or has the issue always been there?
    - Use images and videos to help us understand the issue where possible

    If you are seeking RMA:
    - Please open a new topic rather than hijacking someone else's thread
    - Mark RMA posts with [DEFECTIVE] + <helpful description of issue>. We can then approve/disapprove each request
    - Completed RMA cases will be marked with [CLOSED]
    You can find the RMA guide [here]

    Resolved Issues
    - If you manage to fix an issue, please share your solution for the good of the community. It could help someone else in future.
    - If an issue is resolved the thread should be marked as [RESOLVED]. We can then sticky the thread to help people in future.

    What does troubleshooting support?
    - Hardware queries
    - Hardware issues that weren’t caused by you, e.g DOA board
    - Windows 10 specific issues
    Post Reply
    User avatar
    Posts: 2
    Joined: Tue Nov 27, 2018 11:46 am

    Tue Nov 27, 2018 11:50 am

    Just received my lattepanda alpha.
    Did everything according to manual, booted it to windows - everything is cool, no WIFI tho.
    I've shut down the panda, disconnected power, and connected wifi antenna. After connecting the UCB-C again, no leds are on, it seems dead.
    In total, my latte panda worked for 30 seconds, now its dead. Any advice?

    All the best,

    User avatar
    Posts: 1
    Joined: Fri Nov 23, 2018 6:50 pm

    Tue Nov 27, 2018 7:14 pm

    Have you tried another power source? The included usb-c power adapter was faulty in my case, after trying another one i had, it worked fine.

    User avatar
    Posts: 2
    Joined: Tue Nov 27, 2018 11:46 am

    Tue Nov 27, 2018 11:52 pm

    Yes, i've tried the original one, the one from nintendo switch, one from nintendo switch devkit (0.5A difference), and one fro GPD Pocket, nothing worked.

    Post Reply