LattePanda(Old) Doesn't boot - just red & blue light turned on

If you're having trouble with your LattePanda, here's the place to get help.
Forum rules
    Post technical issues here.

    - Discussion tone should be kept polite and focused on facts
    - Vulgar language or flaming constitutes an instant ban
    - Please note we cannot support PM requests for help
    - Members are asked to post in English only so that posts can be well received and properly monitored
    - You can find the RMA guide [here]
    - Please check if your question has already been answered before opening a new thread. If it has not, please verify the following:

    - Have you tried a hard reset?
    - Are you using a 5V@2A+ power supply and a high quality USB cable?
    - Have you tried powering the board through the CN2 headers?
    - Have you tried a cooling solution such as a fan or heatsink?
    - Have you tried reinstalling drivers?
    - Have you tried reloading the operating system?
    - Have you tried flashing the BIOS?
    - Are you able to flash the BIOS at the hardware level?

    If you have not found a solution, post a new issue. To speed up the process please let us know:
    - Have you tried the solutions listed above?
    - What board are you using? Standard (2GB RAM/32GB eMMC) or Enhanced (4GB RAM/64GB eMMC)?
    - Have you tried any other solutions?
    - How long have you had your board for?
    - When did you first boot your board?
    - Did it work ok before the issue occurred or has the issue always been there?
    - Use images and videos to help us understand the issue where possible

    If you are seeking RMA:
    - Please open a new topic rather than hijacking someone else's thread
    - Mark RMA posts with [DEFECTIVE] + <helpful description of issue>. We can then approve/disapprove each request
    - Completed RMA cases will be marked with [CLOSED]
    You can find the RMA guide [here]

    Resolved Issues
    - If you manage to fix an issue, please share your solution for the good of the community. It could help someone else in future.
    - If an issue is resolved the thread should be marked as [RESOLVED]. We can then sticky the thread to help people in future.

    What does troubleshooting support?
    - Hardware queries
    - Hardware issues that weren’t caused by you, e.g DOA board
    - Windows 10 specific issues
    Post Reply
    User avatar
    Posts: 1
    Joined: Sun Dec 16, 2018 2:44 am

    Sun Dec 16, 2018 2:57 am

    Suddenly my LP didn't boot.
    The red and blue lights still turned on,
    but monitor showed me a black screen.

    I tried hard reset.
    I tried using another cable and another power supply.
    I tried powering through CN2 connector,
    Even though I tried powering through Arduino connector.
    I wasn't able to reinstall drivers & os reinstall & flash new bios
    Because display didn't turn on.

    This is enhanced lattepanda, contains 4GB of ram, 64GB of eMMC.

    Mouse was turned on. Just like lp booted fine.

    I checked it is not issue of HDMI cable or monitor.

    It just showing red light and blue light.
    Sometimes red light just blinking.

    Please somebody help me...

    User avatar
    Posts: 6
    Joined: Fri Sep 02, 2016 9:01 pm

    Mon Feb 18, 2019 11:55 pm

    I'm having the same issue here with my LP original.

    Post Reply