General

MATLAB/ software on Lattepanda

userHead Kxx 2018-08-01 22:13:48 3819 Views1 Replies
Hi everyone, has anyone tried using Lattepanda for running MATLAB? I am currently doing a project which requires a sbc to run program for control of my CMOS camera in which MATLAB was able to control it. I was considering to get a Lattepanda board in which I am not sure if the board was able to run it. If it is able to, I will get it for my project.

In addition, is lattepanda able to support software such as Thorcam (windows compatible) too?
I appreciate the feedback on this topic. Thanks you!


Regards,
Kxx