Panda First Aid

userHead weqin.oran 2023-07-21 22:39:10 152 Views1 Replies

I am pretty sure I just fried the arduino board on my LattePanda Delta 3. Crossed some wires I didn't mean to and then I started to smell smoke. When I open the arduino IDE normally the arduino board shows up in COM3. Now COM3 doesn't exist. However when I use a multi-meter I am still getting some voltage from the pins I was using last.

My question: Is there any potential way for me to save this board? And if not is there somewhere I can send it to to get repaired?